锐客网

  1. 首页 > 睿知 > >

爱普生r330清零错误

经验分享睿知

A. Reset EPSON R330 Printer
1. Turn off the printer.
2. Hold down both the “Power” and “Stop/Maintenance” buttons at the same time.
3. Keep holding down the buttons until the “Power” light starts flashing.
4. Release the buttons and then press the “Stop/Maintenance” button four times.
5. The “Power” light will now be flashing at a faster pace.
6. Press and hold down the “Paper Feed” button for three seconds.
7. Release the “Paper Feed” button and then press the “Power” button.
8. The printer will now reset itself and the “Power” light will stop flashing.
B. Reset EPSON R330 Ink Cartridges
1. Remove the ink cartridges from the printer.
【爱普生r330清零错误】2. Gently shake the cartridges up and down a few times to distribute the ink evenly.
3. Reinsert the cartridges into the printer and close the cover.
4. Turn the printer off for at least 10 minutes.
5. Turn the printer back on and check the ink levels.
C. Check for Printing Errors
1. Make sure that there is no paper jam in the printer.
2. Make sure that the cartridges are inserted correctly.
3. Run a nozzle check to ensure that the printer heads are not clogged.
4. Check the print settings to make sure they are correct.
5. Clean the print head to remove any build-up of ink or dirt.
6. Check the printer software to ensure that it is up to date.
If none of these steps resolves the issue, it is recommended to contact a service technician for further assistance.

    推荐阅读


    上一篇：爱普生l3156关闭固件更新

    下一篇：爱普生351清零说明