锐客网

  1. 首页 > 睿知 > >

佳能废墨满了需要清零

经验分享睿知

【佳能废墨满了需要清零】Canon printer waste ink full need to be reset
1.首先，打开佳能打印机的后盖，然后找到里面的废墨箱 。
First, open the back cover of the Canon printer and then find the waste ink tank inside.
2.取下废墨箱，将废墨箱放在易洒满的容器里，以免弄脏桌面 。
Take out the waste ink tank and put it in a container that is easy to spill, so as not to dirty the desktop.
3.在废墨箱上有一个拧松旋钮，使用扳手将其轻轻拧松，不要拧得太紧，以免损坏废墨箱 。
There is a loosening knob on the waste ink tank. Use a wrench to gently loosen it, not too tight, so as not to damage the waste ink tank.
4.将拧松旋钮拧开，可以看到废墨箱里有通气口，用一支吹气筒将口内废墨吹出 ， 注意力度，以免损坏废墨箱 。
When the loosening knob is opened, you can see that there is an air vent in the waste ink tank. Use an air pump to blow out the waste ink from the vent. Pay attention to the strength, so as not to damage the waste ink tank.
5.将废墨箱放回原位，慢慢拧紧旋钮 ， 将废墨箱固定在原位，确保旋钮拧紧 。
Put the waste ink tank back in place and slowly tighten the knob to fix the waste ink tank in place and make sure the knob is tightened.
6.最后，还需要在佳能打印机设置界面上重置废墨信号，完成清零工作 。
Finally, you need to reset the waste ink signal on the Canon printer settings interface to complete the reset.

    推荐阅读


    上一篇：佳能7280报5b00

    下一篇：g1000佳能5b00错误