锐客网

  1. 首页 > 睿知 > >

佳能 废墨收集器更换视频讲解

经验分享睿知

Canon used ink collector replacement video explanation
【佳能 废墨收集器更换视频讲解】取下废墨收集器
Remove the used ink collector
要取下废墨收集器，首先找到打印机面板上的“更换”按钮 ， 点击一下，将废墨收集器从打印机中间移开 ， 拿出来 。
To remove the used ink collector, first find the “replace” button on the printer panel, click it, remove the used ink collector from the middle of the printer, and take it out.
取下废墨收集器
Remove the used ink collector
取下废墨收集器，然后清洁废墨收集器的表面，将其中的污垢和油污清理干净，并用湿布处理，并且要确保废墨收集器的表面没有污渍 。
Remove the used ink collector, then clean the surface of the used ink collector, remove the dirt and oil stain, and treat it with a wet cloth, and make sure that the surface of the used ink collector is not stained.
安装新的废墨收集器
Install the new used ink collector
取下新的废墨收集器 ， 在打印机面板上的“更换”按钮处放入废墨收集器，使其完全接触打印机内部，然后将废墨收集器旋转，直到它完全嵌入打印机中，并且确保两侧的座位都非常牢固 。
Take out the new used ink collector, put the used ink collector in the “replace” button on the printer panel, make it fully contact the inside of the printer, then rotate the used ink collector until it is fully embedded in the printer, and make sure that both sides of the seat are very firm.
测试废墨收集器
Test the used ink collector
安装完成后，将废墨收集器接通电源 ， 启动打印机 ， 然后可以开始测试废墨收集器是否工作正常 。
After installation, connect the used ink collector to the power supply, start the printer, and then start to test whether the used ink collector works normally.
最后
Finally
取下废墨收集器后，将新的废墨收集器正确安装，确保座位牢固 ， 并且测试设备正常工作，以便给您更好的打印质量 。
After removing the used ink collector, install the new used ink collector correctly, make sure the seat is firm, and test the equipment to work normally, so as to give you better print quality.

    推荐阅读


    上一篇：佳能废墨收集垫更换方法

    下一篇：佳能198 废墨积满